三相生物流化床处理低C/N污水的亚硝化过程控制研究

将短程硝化与生物流化床相结合,采用低碳氮比的人工合成污水进行启动,考察进水COD、氨氮、DO、p H对硝化和亚硝化过程的影响。研究表明,较短的水力停留时间(HRT)和较少的接种污泥量有利于生物膜的生长,能够成功实现生物流化床的快速启动。高进水氨氮浓度有助于反应器实现亚硝酸盐的积累,但是这种积累并不稳定。当反应器中p H为7.5~8.1,ρ(DO)为1.5~2.5 mg/L时,最大亚硝化率达到75%左右,氨氮去除率达85%以上。出水NO-2-N和NO-3-N浓度随进水COD浓度的增加而减少;当进水COD浓度为50 mg/L时,出水硝酸盐浓度急剧减少,亚硝酸盐浓度有所降低,反应器发生同步硝化反硝化脱氮现象。     

铁碳微电解法预处理猪场沼液中氨氮的研究

铁碳微电解是新型的污水处理技术,为了研究猪场沼液中氨氮的去除,将铁碳微电解技术应用于预处理难降解的厌氧沼液中的氨氮。经预先浸泡处理后的铁碳已达到吸附饱和,以此铁碳材料,分别采用了单因素实验和正交试验,用可见光分光光度法测试氨氮的浓度。单因素实验确定了铁碳微电解法影响氨氮去除的因素,选取pH值、反应时间、铁碳比为正交试验因素,通过正交试验得到,当温度为(20±1)℃,铁碳比为1∶1,pH值为3,反应时间为60 min时去除氨氮的效果最好,去除率为34.01%。铁碳微电解法预处理猪场沼液有一定的应用前景。     

外浮顶罐充氮管网设计及有效性试验验证

为了预防外浮顶罐密封圈雷击火灾,提出在密封圈内充入氮气的保护方法.将安全含氧量作为充氮的惰化目标,对外浮顶罐充氮管网进行设计,并通过试验来验证充氮管网的有效性.试验得到了充氮流量、进出气孔数量及管径与有效充氮时间的关系.若以142 m3/h的流量对容量为10×104 m3的外浮顶罐密封圈内充氮,则46.5 min内可以达到充氮惰化目标.雷电预警时间为60 ～ 90 min的条件下,充氮时间小于预警时间,表明所设计的管网是有效的.     

Injuries in Full-Scale Vehicle Side Impact Moving Deformable Barrier and Pole Tests Using Postmortem Human Subjects

Objective: To conduct near-side moving deformable barrier (MDB) and pole tests with postmortem human subjects (PMHS) in full-scale modern vehicles, document and score injuries, and examine the potential for angled chest loading in these tests to serve as a data set for dummy biofidelity evaluations and computational modeling.

Methods: Two PMHS (outboard left front and rear seat occupants) for MDB and one PMHS (outboard left front seat occupant) for pole tests were used. Both tests used sedan-type vehicles from same manufacturer with side airbags. Pretest x-ray and computed tomography (CT) images were obtained. Three-point belt-restrained surrogates were positioned in respective outboard seats. Accelerometers were secured to T1, T6, and T12 spines; sternum and pelvis; seat tracks; floor; center of gravity; and MDB. Load cells were used on the pole. Biomechanical data were gathered at 20 kHz. Outboard and inboard high-speed cameras were used for kinematics. X-rays and CT images were taken and autopsy was done following the test. The Abbreviated Injury Scale (AIS) 2005 scoring scheme was used to score injuries.

Results: MDB test: male (front seat) and female (rear seat) PMHS occupant demographics: 52 and 57 years, 177 and 166 cm stature, 78 and 65 kg total body mass. Demographics of the PMHS occupant in the pole test: male, 26 years, 179 cm stature, and 84 kg total body mass. Front seat PMHS in MDB test: 6 near-side rib fractures (AIS = 3): 160–265 mm vertically from suprasternal notch and 40–80 mm circumferentially from center of sternum. Left rear seat PMHS responded with multiple bilateral rib fractures: 9 on the near side and 5 on the contralateral side (AIS = 3). One rib fractured twice. On the near and contralateral sides, fractures were 30–210 and 20–105 mm vertically from the suprasternal notch and 90–200 and 55–135 mm circumferentially from the center of sternum. A fracture of the left intertrochanteric crest occurred (AIS = 3). Pole test PMHS had one near-side third rib fracture. Thoracic accelerations of the 2 occupants were different in the MDB test. Though both occupants sustained positive and negative x-accelerations to the sternum, peak magnitudes and relative changes were greater for the rear than the front seat occupant. Magnitudes of the thoracic and sternum accelerations were lower in the pole test.

Conclusions: This is the first study to use PMHS occupants in MDB and pole tests in the same recent model year vehicles with side airbag and head curtain restraints. Injuries to the unilateral thorax for the front seat PMHS in contrast to the bilateral thorax and hip for the rear seat occupant in the MDB test indicate the effects of impact on the seating location and restraint system. Posterolateral locations of fractures to the front seat PMHS are attributed to constrained kinematics of occupant interaction with torso side airbag restraint system. Angled loading to the rear seat occupant from coupled sagittal and coronal accelerations of the sternum representing anterior thorax loading contributed to bilateral fractures. Inward bending initiated by the distal femur complex resulting in adduction of ipsilateral lower extremity resulted in intertrochanteric fracture to the rear seat occupant. These results serve as a data set for evaluating the biofidelity of the WorldSID and federalized side impact dummies and assist in validating human body computational models, which are increasingly used in crashworthiness studies.     

Influence of Riparian Seepage Zones on Nitrate Variability in Two Agricultural Headwater Streams

Riparian seeps have been recognized for their contributions to stream flow in headwater catchments, but there is limited data on how seeps affect stream water quality. The objective of this study was to examine the effect of seeps on the variability of stream NO₃‐N concentrations in FD36 and RS, two agricultural catchments in Pennsylvania. Stream samples were collected at 10‐m intervals over reaches of 550 (FD36) and 490 m (RS) on 21 occasions between April 2009 and January 2012. Semi‐variogram analysis was used to quantify longitudinal patterns in stream NO₃‐N concentration. Seep water was collected at 14 sites in FD36 and 7 in RS, but the number of flowing seeps depended on antecedent conditions. Seep NO₃‐N concentrations were variable (0.1‐29.5 mg/l) and were often greater downslope of cropped fields compared to other land uses. During base flow, longitudinal variability in stream NO₃‐N concentrations increased as the number of flowing seeps increased. The influence of seeps on the variability of stream NO₃‐N concentrations was less during storm flow compared to the variability of base flow NO₃‐N concentrations. However, 24 h after a storm in FD36, an increase in the number of flowing seeps and decreasing streamflow resulted in the greatest longitudinal variability in stream NO₃‐N concentrations recorded. Results indicate seeps are important areas of NO₃‐N delivery to streams where targeted adoption of mitigation measures may substantially improve stream water quality.     

Quantification of nitrogen in the liquid fraction and in vitro assessment of lysine bioavailability in the solid fraction of soybean meal hydrolysates

Soybean meal (SBM) is a product generated from the manufacture of soybean oil and has the potential for use as a source of fermentable sugars for ethanol production or as a protein source for animal feeds. Knowing the levels of nitrogen available from ammonium is a necessary element of the ethanolic fermentation process while identifying the levels of essential amino acids such as lysine is important in determining usage as a feed source. As such the purpose of this study was to quantify total nitrogen and ammonium in the liquid fraction of hydrolyzed SBM and to evaluate total and bioavailable lysine in the solid fraction of the hydrolyzed SBM. The effects of acid concentration, cellulase and β-glucosidase on total and ammonium nitrogen were studied with analysis indicating that higher acid concentrations increased nitrogen compounds with ammonium concentrations ranging from 0.20 to 1.24 g L^?1 while enzymatic treatments did not significantly increase nitrogen levels. Total and bioavailable lysine was quantified by use of an auxotrophic gfpmut3 E.coli whole-cell bioassay organism incapable of lysine biosynthesis. Acid and enzymatic treatments were applied with lysine bioavailability increasing from a base of 82% for untreated SBM to up to 97%. Our results demonstrated that SBM has the potential to serve in ethanolic fermentation and as an optimal source essential amino acid lysine.     

分段变速加载对含瓦斯突出煤力学特性影响试验研究

为探究采动应力变化对含瓦斯突出煤力学特性的影响，利用RLW-500G煤岩三轴蠕变-渗流试验系统，对新景矿含瓦斯突出煤进行了不同围压和瓦斯压力下的常规三轴和分段变速加载力学试验。结果表明:煤样在2种应力路径下的全应力应变曲线均可分为压密、线弹性、塑性变形、应力跌落和残余应力5个阶段；随着围压的升高或者瓦斯压力的降低，煤体在2种应力路径下的强度和弹性模量均增大；相较于常规三轴，煤体在分段变速加载路径下的强度普遍增大，峰值轴向应变、峰值环向应变绝对值和峰值体积应变绝对值也普遍增大，失稳破坏瞬间应力跌落和能量释放更加剧烈。Mohr-Coulomb强度准则仍然适用于分段变速加载条件下的含瓦斯突出煤，该研究对于认识煤与瓦斯突出的发生机制具有一定的指导意义。     

液氮泡沫发生器内流动特性研究

低温液氮与泡沫混合液直接接触产生氮气泡沫是一种新型的掺混形式,利用液氮高汽化比的特点,搭建液氮泡沫可视化实验装置,进行氮气-水两相流及液氮泡沫流动特性的研究。结果表明,液氮相变产生大量氮气,其与泡沫液混合产生泡沫,温度有所回升,最终趋于泡沫混合液温度;管路沿程压降较小;液氮射流破碎及流动过程可分为6个区域:低温液氮区、向上循环翻滚区、滞留区、泡沫与泡沫混合液混合区、致密泡沫区、泡沫混合液区。流体向下游流动过程中持续发泡;为防止管路结冰,需合理控制泡沫混合液与液氮流量。     

湖库型水体总氮总量控制目标的区域分配研究

基于层次分析法原理,以资源禀赋、社会经济、农业生产生活、污染治理水平为主要考虑因素设计指标体系和层次结构,建立了湖库型水体总氮总量控制目标分配方法,并在石头口门水库流域进行了应用,为湖库型水体总氮总量控制目标分配及石头口门水库流域总氮总量控制提供借鉴。     

光/电法氨氮降解过程中协同作用的研究

为了研究光/电法在氨氮降解过程中的协同作用,采用光/电法降解模拟工业循环冷却水中的氨氮,并对氨氮降解过程中的各影响因素进行了研究,考察了氯离子浓度和溶液p H对降解效率的影响。结果表明,与传统的光催化法和电化学法相比,光/电法在氨氮降解过程中存在良好的协同效应,因而具有更高的氨氮去除率,这主要归功于溶液氯离子的促进作用。另外,在酸性条件下,氨氮降解效率得到进一步加强。当p H在4~5之间,电流密度为10 m A/cm2,Na Cl浓度为100 mg/L时,在经过90 min光/电法处理后氨氮去除率高达95%,且N2占总氨氮降解产物的84.2%。